Delta 46-715 Uživatelský manuál stáhnout pdf (Strana 10)

70166

70140, 70141

70138

70130

MAINTENANCE

Keep your RING MASTER® clean. If compressed

air is available, blow each part clean after use. Keeping

the lead screw clean of saw dust is very important.

ADJUSTMENTS

End play may occur in the lead screw. If it occurs,

correct the situation as follows:

LEAD SCREW: Loosen set screw on handle

(Reference #31) and press tool holder (Reference #23)

toward handle (Reference #32). As you press handle

toward tool holder tighten set screw.

TROUBLE SHOOTING

WARNING: For your safety, turn switch "off" and always remove plug from power source before

trouble shooting.

TROUBLE PROBABLE CAUSE REMEDY

Cutting Feed too Fast Advance Cutter Slowly

Chattering Dull Cutter Sharpen or Change Cutter

Blade Misalignment Realign Cutters

Excessive Chipping Feed too Fast Slow Down

Cutter Darkens Cutter Dull Sharpen or Replace Cutter

Excessive Vibration Base Not Clamped Clamp or Bolt Base Down

Feed Screw Binding Dirt or Dust Build-up Dis-assemble - Clean

Use Multipurpose Grease

1 2 ... 5 6 7 8 9 10 11 12 13

Žádné komentáře

Delta 46-715 Uživatelský manuál Strana 10