Delta 28-682 Manuál s instrukcemi

INSTRUCTION MANUAL18" Band Saw(Model 28-682)PART NO. 911988 - 07-28-04Copyright © 2004 Delta MachineryTo learn more about DELTA MACHINERY visit o

1. Remove the table pin (A) Fig. 5.2. Align the blade with the table slot (B) Fig. 5. Slide the table until the blade has reached the center cutout (C

11FENCE1. Align the two holes (A) Fig. 9 in the front fence rail with the two holes (B) in the front of the table.NOTE: Make sure that the scale on th

12STARTING AND STOPPING SAWThe power switch is located on the left side of the machine. To turn the machine “ON”, push the green start button (A)Fig.

134. Raise the blade tension lever to the “up” positionand turn it clockwise to increase tension or counter-clockwise to relieve the tension.5. After

The lower bearing adjustments are similar to the upper bearingadjustments. Adjust the blade support bearing (A) Fig 23 so thatit is within 1/64” of, b

15Fig. 24This machine is equipped with a positive stop thatallows the table to be rapidly positioned at 90 degrees tothe blade after the table has bee

16Fig. 28AADJUSTING BELT TENSIONIf it becomes necessary to adjust the belt tension on the machine, turn the motor release handle (A) Fig. 28A counter-

17BAND SAW BLADESA band saw blade is a delicate piece of steel that is subjected to tremendous strain. You can obtain long use from aband saw blade if

18Trouble: BAND SAW VIBRATES EXCESSIVELY.Probable Cause Remedy1. Machine not mounted securely to stand. 1. Tighten all mounting hardware.2. Stand on u

19MAINTENANCEPARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.ADDITIONAL SAFETY RULES FOR BAND SAWSSAVE THESE INSTRUCTIONS. Refer to them often

66A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp t

73. Grounded, cord-connected machines intended foruse on a supply circuit having a nominal ratingbetween 150 - 250 volts, inclusive:If the machine is

8FOREWORDDelta Model 28-682 is an 18" Wood Cutting Band Saw. This machine has speeds of 2300 and 3250 SFPM (surface feetper minute). Its blade to

Carefully unpack the machine and all loose items fromthe shipping container(s). Remove the protective coatingfrom all unpainted surfaces. This coating