Delta 32-325 Manuál s instrukcemi

INSTRUCTION MANUALTo learn more about DELTA MACHINERY visit our website at: www.deltamachinery.com.For Parts, Service, Warranty or other Assistance,pl

101. Place the spacer (A) Fig. 9 over the hole (B) in thetable bracket with the large countersunk end of thespacer (A) in the “up” position.2. Place a

114. With the index pins (B) Fig. 13 engaged in the gauge holes (A), loosen the table lock knobs, one of which is shownat (E). Move the table until th

121. Remove the retaining ring (A) Fig. 17 and remove the connecting pin (B).2. Insert the end of the operating handle (C) Fig. 18 into the head assem

131. Remove the protective cover from the guard.2. Engage the two slots (B) Fig. 22 on the plastic guard (A) with the two spacers and screws (C) and s

MOVING THE FENCE AND TABLEDISCONNECT MACHINE FROM POWER SOURCEYou can move the fence and table in or out to bore holes up to four inches from the edge

15SETTING THE FENCE STOPSDISCONNECT MACHINE FROM POWER SOURCETwo fence stops - one right (A) Fig. 30, and one left (B) - are supplied with your boring

161. A typical line-boring operation is shown in Fig. 34.Note that the right end of the workpiece is positionedagainst the fence stop (A) and 13 holes

17TROUBLESHOOTING GUIDEFor assistance with your tool, visit our website at www.deltamachinery.com for a list of service centers or call theDELTA Machi

18A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,and Delta Authorized Service Stat

19Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.ADDITIONAL SPECIFIC SAFETY RULESSAVE THESE INSTRUCTIONS. Refer to them often and

6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

7EXTENSION CORDSUse proper extension cords. Make sureyour extension cord is in good condition and is a 3-wireextension cord which has a 3-prong ground

8ASSEMBLYASSEMBLY TOOLS REQUIREDASSEMBLY TIME ESTIMATE5/16" wrench (not supplied)1/4" wrench (not supplied)Approximately two hours.If you pu

91. Clip the two table slides (A) Fig. 3 in the tablebracket (B).2. Clip the remaining two table slides in the other tablebracket.3. Center the table