Delta DP400 Uživatelský manuál

INSTRUCTION MANUAL16½" Floor Model Drill Press(Model DP400)PART NO. 907453 - 04-13-04Copyright © 2004 Delta MachineryESPAÑOL: PÁGINA 21To learn m

10Fig. 99. Insert table (H) Fig. 9, into hole in table bracket asshown.Fig. 1010. Thread table locking lever (J) Fig. 10, into hole infront of table b

11Fig. 1414. IMPORTANT: Make certain the spindle taper (O) Fig.14, and tapered hole in chuck (P) are clean and free ofany grease, lacquer or rust prev

1218. Align the two holes in the lamp bracket (A) Fig. 17,with the two holes (B) on the side of the drill press head.Fig. 1720. Align the two holes in

13OPERATING CONTROLS AND ADJUSTMENTSSTARTING AND STOPPINGDRILL PRESSThe switch (A) Fig. 20, is located on the front of the drillpress head. To turn th

14Fig. 24CE3. The table can be tilted right or left by pulling out andremoving table alignment pin (C) Fig. 24. NOTE: If pin (C)is difficult to remove

15SPINDLE SPEEDSTwelve spindle speeds are available on the drill press. Fig. 27, illustrates which steps of the pulleys the belts must beplaced to obt

16DRILLING HOLES TO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, a depth stop is provided and is used asfollows:DISCONNECT

17OPERATIONSFig. 32Your drill press is to be used with drill bits with a shank of5/8" or less in diameter. The following will give theinexperienc

18BORING IN WOODTwist drills, although intended for metal drilling, may also be used for boring holes in wood. However, machine spur bitsare generally

19NOTES

2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

20PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

3GENERAL SAFETY RULES1. FOR YOUR OWN SAFETY, READ THE INSTRUCTIONMANUAL BEFORE OPERATING THE MACHINE.Learning the machine’s application, limitations,

4ADDITIONAL SAFETY RULES FOR FOR DRILL PRESSES1. DO NOT OPERATE THIS MACHINE until it iscompletely assembled and installed according tothe instruction

5A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

6Fig. CGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESEXTENSION CORDSFOREWORDDelta ShopMaster DP400 is a 16½" d

7UNPACKING AND CLEANINGCarefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating fromall unpainte

8ASSEMBLYFOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE

96. Assemble the column (A) Fig. 6, to the base (B) usingthe four M10x40mm hex head screws (C), three of whichare shown.Fig. 67. Assemble table raisin