Delta MS265 Manuál s instrukcemi stáhnout pdf (Strana 10)

A TURNING SAW BLADE CAN BE DANGEROUS. AFTER COMPLETING THE CUT, RELEASE THE

SWITCH TRIGGER (A) FIG. 9 TO ACTIVATE THE BLADE BRAKE. KEEP THE CUTTINGHEAD DOWN

UNTIL THE BLADE HAS COME TO A COMPLETE STOP.

STARTING AND STOPPING THE

MITER SAW

THE TORQUE DEVELOPED DURING BRAKING MAY LOOSEN THE ARBOR SCREW. CHECK THE

ARBOR SCREW PERIODICALLY AND TIGHTEN, IF NECESSARY.

LOCKING THE SWITCH IN THE

“OFF” POSITION

WHEN THE MACHINE IS NOT IN USE,

THE SWITCH SHOULD BE LOCKED IN

THE “OFF” POSITION, USING A

PADLOCK (B) FIG. 10 WITH A 3/16"

DIAMETER SHACKLE TO PREVENT

UNAUTHORIZED USE.

To start the miter saw, depress the switch trigger (A) Fig.

9. To stop the miter saw, release the switch trigger.

This saw is equipped with an automatic electric blade

brake. As soon as the switch trigger (A) Fig. 9 is

released, the electric brake is activated and stops the

blade in seconds.

Fig. 9

Fig. 10

OPERATION

TABLE HAZARD AREA

THE AREA INSIDE THE TWO RED

LINES ON THE TABLE (A) FIG. 11 IS

DESIGNATED AS A "HAZARD ZONE".

NEVER PLACE YOUR HANDS INSIDE

THIS AREA WHILE THE MACHINE IS

RUNNING.

Keep your hands out of the path of the

saw blade. If necessary, clamp the

workpiece in place before making the

cut.

Fig. 11

WORK CLAMP

Fig. 12

Some Delta miter saws come with a work clamp. If your

machine has a work clamp, you can position it in one of

two holes (B) Fig 12 in the left or right side of the base.

Use this clamp, especially with short workpieces.

OPERATING CONTROLS AND ADJUSTMENTS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Komentáře k této Příručce

Žádné komentáře

Delta MS265 Manuál s instrukcemi Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Kotoučové pily Delta MS265