Delta 36-255L Manuál s instrukcemi stáhnout pdf (Strana 9)

MOVING TABLE TO THE 0° CUT-OFF

POSITION

1. Rotate locking knob (A) Fig. 6 counter-clockwise as

far as it will go. Depress lever (B) and rotate table (C)

to the 0° straight cut-off position, release lever (B),

and tighten locking knob (A).

2. Fig. 7 illustrates the table (C) in the 0° straight cut-off

position.

3. For proper operation and adjustment of the table,

refer to sections, “ROTATING TABLE FOR MITER

CUTTING” and “ADJUSTING SLIDING FIT

BETWEEN MOVABLE TABLE AND BASE.”

ATTACHING EXTENSION TABLE AND

FENCE SLIDE

1. Attach flat washers to the two 5/16-18 x 3/4” screw

assemblies (A) Fig. 7A, and thread into the threaded

holes on left side of the saw.

NOTE: Turn the screws only a few threads into the holes

at this time.

2. Attach the table extension (B) Figs. 7A and 7B, to left

side of saw table, making sure groove of table

extension (B) is inside flat washers (C) as shown in

Fig. 7B.

3. Use a straight edge (C) Fig. 7C, to make the

extension table (B) even with saw table (D), and

tighten the two screws (C) Fig. 7B.

Fig. 6

Fig. 7

Fig. 7A

Fig. 7B

Fig. 7C

Fig. 5

MOVING CUTTINGHEAD TO THE UP POSITION

1. Pull out cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B)

to the up position.

2. Fig. 5, illustrates the lockpin (A) pulled out and the cuttinghead (B) in

the up position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Žádné komentáře

Delta 36-255L Manuál s instrukcemi Strana 9