Delta 36-978 Manuál s instrukcemi

www.deltamachinery.com(800) 223-7278 - US(800) 463-3582 - CANADA10" Contractors Saw(Model 36-978/36-979)Recolector de Polvo Portátil de Etapa Sen

108. Place the intake funnel assembly (A) on the lower support tube (B) Fig. 14. Secure it with a tube clamp (C).Fig. 14A C B ATTACHIN

1111Loosely thread the end of the dust bag strap (A) through the clamp (B) (Fig. 19). Place the open end of the dust bag (C) Fig. 19 over the outlet f

1212MACHINE USEThis versatile dust collector is light, compact. It can easily be transported for use in and out of the workshop. The dust collector ca

13Always disconnect the machine from the power source before performing any maintenance procedures.Check the condition of the dust bag periodically fo

14Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine

40The following are trademarks of PORTER-CABLE • DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marques suivantes son

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. When using tools or equipment, basi

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

1. FOR YOUR OWN SAFETY, READ THE INSTRUCTION MANUAL BEFORE OPERATING THE MACHINE. Learning the machine’s application, limitations, and specific hazar

ADDITIONAL SPECIFIC SAFETY RULES FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.SAVE THESE INSTRUCTIONS.Refer to them oftenand use them to

6EXTENSION CORDSUse proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grou

771. Dust collector2. Hose3. Dust bag4. Exhaust flange5. Exhaust flange gasket6. Intake funnel7. Intake support angle brace8. Upper support bracket9

88INSTALLING THE CASTERS 1. Place the dust collector on its side.2. Insert a caster through the four holes (A) Fig. 3 in the base of the dust collec

99INSTALLING THE DUST PORT TUBE AND THE DUST COLLECTOR CONNECTORDisconnect the machine from the power source!1. Place the tube clamp (A) Fig. 7 on th