Delta 3 H.P. SINGLE-STAGE DUST COLLECTOR 50-853 Manuál s instrukcemi

INSTRUCTION MANUAL3 H.P. Single-StageDust Collector(Model 50-852, three phase)(Model 50-853, single phase)PART NO. 902108 - 06-27-02Copyright © 2002 D

10Fig. 26Fig. 284. Pull up on each retaining clip (A) Fig. 26, and insertthe dust collection bag (B) underneath each retaining clipto hold the dust co

11Fig. 29Fig. 30Fig. 31ASSEMBLING DUST INTAKEPORT TO BLOWER ANDMOTOR ASSEMBLYMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.1. A

12Fig. 32Fig. 33Fig. 34Fig. 35MODEL 50-853SINGLE PHASEINSTALLATIONYour dust collector is supplied with a motor andcontroller; however, it is not suppl

13OPERATING CONTROLSON/OFF SWITCH(Model 50-852)The “on/off” switch is located on the side of the motorstand. To turn the dust collector “ON”, push but

14NOTES

15Printed in U.S.A.PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORDUST COLLECTORSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE

4UNPACKING AND CLEANINGCarefully unpack the tool and all loose items from the shipping container(s). Remove the protective coating from allunpainted s

5Fig. 5Fig. 6Fig. 7Fig. 8ASSEMBLING CASTERASSEMBLIES TO BASEAlign the holes in caster assembly (A) Fig. 5, with fourholes in support stand (B) located

6Fig. 9Fig. 10Fig. 11Fig. 124. Apply a bead of silicone sealant around flange ofchute (F) Fig. 9. Align holes in ten-hole gasket (G) Fig. 9,with mount

7Fig. 13Fig. 14Fig. 15Fig. 177. Apply a bead of silicone sealant around flange ofchute (H) Fig. 14. Align holes in eight-hole gasket (K) Fig.14, with

8Fig. 18Fig. 19Fig. 21Fig. 2011. Align two mounting holes in the top of drum supportarm (T) Fig. 18, with two pre-drilled holes in drum (N)and fasten

9Fig. 22Fig. 23Fig. 24Fig. 25ASSEMBLING FILTERAND DUST COLLECTIONBAGS TO DRUM1. Hook the loop on the top of filter bag (A) Fig. 22, ontofilter bag sup