Delta 36-444 Manuál s instrukcemi stáhnout pdf (Strana 15)

Fig. 34

Fig. 35

Fig. 36

10. Using a straight edge, check to see if the saw blade

is aligned with the rear of the splitter (G), as shown in

Figs. 34 and 35. If alignment is necessary, loosen the

two splitter mounting screws located at (A), align splitter

(G) with the saw blade, and tighten two screws (A).

11. Lower saw blade and install table insert (P) Fig. 36,

in the saw table as shown. IMPORTANT: When installing

the table insert, always make certain to hold on to the

blade guard (L). The insert will automatically release the

holding action on the splitter and lower the blade guard

when it is installed in the table opening.

NOTE: Table insert adjustment is described later in

ADJUSTING TABLE INSERT.

Fig. 37

Fig. 38

ASSEMBLING

EXTENSION WING

1. Assemble extension wing (A) Fig. 37, to the saw

table using three 7/16-20 x 3/4″ screws (B) and flat

washers (C) only one of each is shown.

2. With a straight edge (D) Fig. 37, make certain the

extension wing (A) is level with the saw table before

tightening three screws (B).

ASSEMBLING SWITCH

ASSEMBLY

1. Assemble switch bracket (A) Fig. 38, to the front of

extension wing (B) and fasten with 3/8-16 x 1″ long

carriage head bolt, flat washer, and hex nut (C). Note:

When installing the UniRip Fence, this bolt must be

loosened.

NOTE: Model 36-445 with the Unifence is assembled

the same way, but requires different hardware.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Žádné komentáře

Delta 36-444 Manuál s instrukcemi Strana 15