Delta 36-444 Manuál s instrukcemi stáhnout pdf (Strana 21)

OPERATIONS

Common sawing operations include ripping and cross-cutting, plus a few other standard operations of a

fundamental nature. As with all power tools, there is a certain amount of hazard involved with the operation and

use of the machine. Using the machine with the respect and caution demanded as far as safety precautions are

concerned will considerably lessen the possibility of personal injury. However, if normal safety precautions are

overlooked or completely ignored, personal injury to the operator can result.

Fig. 57

CROSS-CUTTING

Cross-cutting requires the use of the miter gage to

position and guide the work. Place the work against the

miter gage and advance both the gage and work toward

the saw blade, as shown in Fig. 57. The miter gage may

be used in either table slot. When bevel cutting (blade

tilted), use the table groove that does not cause

interference of your hand or miter gage with the saw

blade guard.

Start the cut slowly and hold the work firmly against the

miter gage and the table. One of the rules in running a

saw is that you never hang onto or touch a free piece of

work. Hold the supported piece, not the free piece that

is cut off. The feed in cross-cutting continues until the

work is cut in two, and the miter gage and work are

pulled back to the starting point. Before pulling the work

back, it is good practice to give the work a little

sideways shift to move the work slightly away from the

saw blade. Never pick up any short length of free work

from the table while the saw is running. Never touch a

cut-off piece unless it is at least a foot long.

For added safety and convenience the miter gage can

be fitted with an auxiliary wood-facing (C), as shown in

Fig. 58, that should be at least 1 inch higher than the

maximum deth of cut, and should extend out 12 inches

or more to one side or the other depending on which

miter gage slot is being used. This auxiliary wood-facing

using two wood screws (A) through the holes provided in

the miter gage body and into the wood-facing.

WARNING: NEVER USE THE FENCE AS A CUT-

OFF GAGE WHEN CROSS-CUTTING.

When cross-cutting a number of pieces to the same

length, a block of wood (B) can be clamped to the fence

and used as a cut-off gage as shown in Fig. 59. It is

important that this block of wood always be positioned

in front of the saw blade as shown. Once the cut-off

length is determined, secure the fence and use the miter

gage to feed the work into the cut.

This block allows the cut-off piece to move freely along

the table surface without binding between the fence and

the saw blade, thereby eliminating the possibility of

kickback and injury to the operator.

IMPORTANT: When using the block (B) Fig. 59, as a cut-off

gage, it is very important that the rear end of the block be

positioned so the work piece is clear of the block before it

enters the blade.

Fig. 58

Fig. 59

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Delta 36-444 Manuál s instrukcemi Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Pokosové pily Delta 36-444