Delta 36-444 Manuál s instrukcemi stáhnout pdf (Strana 19)

Fig. 49

Fig. 50

Fig. 51

Fig. 52

ADJUSTING TABLE INSERT

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

Place a straight edge across the table at both ends of

the table insert as shown in Fig. 52. The table insert (A)

should always be level with the table. If an adjustment is

necessary, turn the adjusting screws (B), as needed.

Four adjusting screws (B) are supplied in the table insert.

The table insert is equipped with a convenient finger

hole (C) for easy removal.

MITER GAGE OPERATION

AND ADJUSTMENT

Insert the miter gage bar into the miter gage slot and

assemble the washer and lock handle (A) Fig. 49, to

the miter gage bar as shown. Insert cap (K) into top of

handle (A).

The miter gage is equipped with adjustable index stops

at 90 degrees and 45 degrees right and left. Adjustment

to the index stops can be made by tightening or

loosening the three adjusting screws (B) Fig. 50.

To rotate the miter gage, loosen lock knob (A) Fig. 50,

and move the body of the miter gage (C) to the desired

angle.

The miter gage body will stop at 90 degrees and 45

degrees both right and left. To rotate the miter gage

body past these points, the stop link (D) Fig. 50, must be

moved up and out of the way.

The miter gage is equipped with a special washer (E)

Fig. 51, and flat head screw (F), which are to be

assembled to the end of the miter gage bar.

The head of the miter gage pivots on a special tapered

screw (G) that fastens the head to the miter gage bar.

If the miter gage head does not pivot freely, or pivots

too freely, it can be adjusted by loosening set screw (H)

Fig. 51, and turning the screw (G), in or out. Be certain

to tighten screw (H) after adjustment is made.

5. Depending on the type of saw blade being used, the

cursor (D) Fig. 48, may need adjustment to compensate

for the blade thickness.To adjust the cursor, make a test

cut on a piece of lumber and measure the finished cut,

or you can place the rip fence against the blade as

shown earlier in the manual. If a minor adjustment is

necessary, loosen two screws (E) Fig. 48, and move the

cursor (D) as necessary.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Delta 36-444 Manuál s instrukcemi Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Pokosové pily Delta 36-444