Delta 36-444 Manuál s instrukcemi stáhnout pdf (Strana 11)

Fig. 16

Fig. 17

ASSEMBLING MOTOR

PULLEY, BELT AND

PULLEY GUARD, AND

DRIVE BELT

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

1. Remove the motor shaft key that is taped to the

motor.

2. Insert the key (A) Fig. 16, in the keyway on the motor

shaft. Assemble the motor pulley (B) on the motor shaft

as shown, with the hub of the pulley out. Loosely tighten

set screw (C) against key (A) in motor shaft.

3. Remove wing nut and external tooth lockwasher (D)

Fig. 17, and outer cover (E) from belt and pulley guard (G).

Fig. 18

Fig. 19

4. Slide the belt and pulley guard bracket (G) Fig. 18,

between the motor base plate (M) and motor mounting

plate(L), as shown. Do not completely tighten the four

hex nuts that fasten the motor to the motor mounting

plate at this time.

5. Position belt and pulley guard bracket (G) Fig. 19, so

the motor pulley (B) is centered and through the hole in

the belt and pulley guard bracket, as shown.

6. Using a straight edge (A) Fig. 19 align the motor

pulley (B) with the arbor pulley(C). Tighten the motor

pulley set screw and the four hex nuts that fasten the

motor to the motor mounting plate.

7. Lift up on the motor and assemble the drive belt (H)

Fig. 20, to the arbor pulley and motor pulley (B). The

weight of the motor will provide the correct belt tension.

Fig. 20

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Žádné komentáře

Delta 36-444 Manuál s instrukcemi Strana 11