Delta 36-444 Manuál s instrukcemi stáhnout pdf (Strana 8)

ASSEMBLY INSTRUCTIONS

WARNING: MAKE SURE THE SAW IS SECURELY ATTACHED TO THE STAND BEFORE PERFORMING ANY

CUTTING OPERATIONS. DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE

ENTIRE INSTRUCTION MANUAL.

Fig. 5

Fig. 6

Fig. 7

ASSEMBLING SAW STAND

1. Assemble the dust chute and support panel (A)

Fig. 5, to the inside of the front stand panel (B) with three

#10 x 1/2″ sheet metal screws (C).

2. Insert four #10-32 x 1/2″ screws (D) Fig. 6 through

support panel and dust chute. Install four #10-32 hex

nuts (E) Fig. 6. NOTE: The front stand panel will have the

saw identity labels facing you. Do not completely tighten

the stand hardware at this time. Also, make certain the

dust chute/support panel (A) Fig. 6, is located under the

lip of front stand panel (B).

3. Assemble the other end of dust chute and support

panel (A) Fig. 7, to rear stand panel (F) as shown with

four #10-32 x 1/2″ screws and #10-32 hex nuts, which

are shown at (C). NOTE: Do not completely tighten stand

hardware at this time.

Fig. 8

ASSEMBLING

SAW TO STAND

1. Turn saw table face down. Place stand (B) Fig. 8,

onto saw (A). Align eight holes in the stand (B) with

mounting holes in the saw (A) and fasten with eight 5/16"-

18 screws, flat washers, lockwashers, and hex nuts one

of which is shown at (C) Fig. 8. Assemble flat washers

onto screws, place screws through holes, assemble

lockwashers then hex nuts finger tight. Do not

completely tighten hardware at this time.

2. Install four rubber feet (D) Fig. 8, on the end of each

stand leg (B).

3. Turn saw table face up.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Žádné komentáře

Delta 36-444 Manuál s instrukcemi Strana 8