Delta RMC101 Uživatelský manuál stáhnout pdf (Strana 144)

100

101

RMC100 and RMCWin User Manual

3-94

3. Change any options on this page.

4. Click OK.

The Graph tab has the following sections:

• Additional Plot Values

This section controls the plotting of velocity and acceleration. From this section you can turn on or

off the velocity and acceleration plots, set the color of the velocity and acceleration plots, and set

the zero line color. The zero line is a line drawn at zero velocity and acceleration. See Showing

Velocity and Acceleration for details.

• Graph Scale

This section allows you to set the scale of the time (or master position), position, velocity, and

acceleration plots. Increasing each value will zoom in. Decreasing a value will zoom out. See

Adjusting the Scales for details.

• Grids

This section controls whether there is a grid, and if there is a grid, what type of grid is displayed.

See Using the Grid for details. This area also lets you turn the scale bars on or off. See Using the

Scale Bars for details.

• Orientation

This section controls whether time (or master position) is displayed as increasing from left to right

or from top to bottom. You can use this setting to better match your application's orientation. For

example, parison profiles are typically viewed vertically, so using the vertical orientation may be

clearer in that application. See Changing the Orientation for details.

See Also: Curve Tool Topics

3.9.4.2 Curve Tool: Showing Velocity and Acceleration

For all selected curves, the curve is drawn as position with respect to time (or master units). You

can also have the Curve Tool plot the velocity and/or acceleration with respect to time (or master

position). These plots are shown on top of the position plot.

A zero line is drawn at the midline of the Graph view. This line is not affected by scrolling the

Graph view.

The velocity and acceleration plots always apply to the active curve. Therefore, switching to

another active axis will cause these plots to be redrawn for the new axis.

Velocity and acceleration plots can be turned on and off. You can also select the colors used for

these plots and the color of the zero line. These steps are described below.

There are two ways of changing the velocity and acceleration scales. You can manually enter a

scale value, as described in Adjusting the Scales, and you can drag the scale bars, as described

in Using the Scale Bars.

In addition to the velocity plot and scale bar, dotted lines are drawn at the positive and negative

speed limits in the same color as the velocity plot. Similar lines are drawn at the acceleration

limits. See Curve Limits for details.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 950 951

Komentáře k této Příručce

Žádné komentáře

Delta RMC101 Uživatelský manuál Strana 144

Komentáře k této Příručce

Související produkty a manuály pro Senzory Delta RMC101