Delta RMC101 Uživatelský manuál stáhnout pdf (Strana 184)

100

101

RMC100 and RMCWin User Manual

3-134

ensure that the program starts with the correct settings. Notice that most users will have no need

for these options because they are saved from one execution of RMCWin to another. Options

given on the command-line override the previously saved settings.

The following options are available:

-1, -2,

-3, -4

Select COM1, COM2, COM3 or COM4 as the serial port to use. This will

override any communication path setting for the current board file.

-Dn

Generate a debug log file named Debug.txt in the current directory. The

logging level is controlled by n, which can be from 0 (no logging) to 5 (most

logging). There is no logging enabled by default.

-F Force initialization onto module. See Forcing Initialization for details.

-L Start in Look-only mode. See Using Look-only Mode for details.

-M

Allow multiple instances of RMCWin to run at once with the same board file

open. The copy of RMCWin that is started with this command and all

subsequent RMCWin instances started can run at the same time. This will

continue until the Limit Instances to One per Board File check box on the

Preferences tab of the Options dialog box is set.

-P

Start RMCWin with the communication path closed. This can be used for

demonstrations or offline editing.

-R

Start in Read-back mode. See Read-back versus Write Mode for details.

-W

Start in Write mode. See Read-back versus Write Mode for details.

Board

file

The parameter after the filename that does not start with a ’r;-’ or ’r;/’ gives

the board filename that is used on startup (e.g. rmcwin carriage.bd1). See

Using Multiple Motion Modules for details on board files.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 950 951

Komentáře k této Příručce

Žádné komentáře

Delta RMC101 Uživatelský manuál Strana 184

Komentáře k této Příručce

Související produkty a manuály pro Senzory Delta RMC101